Ram air again...

... and hopefully the last post for a while.  It's 99% there, i'm just going to run some silicon sealant on joins to make it 100% air tight and glass in some mounting lugs to hold it in place.

 Clearance is a bit tight, but it fits.

Current panic is over one of the engine mounts not lining up, i need to take out the crash bungs to figure out where the holes should go, so hopefully it'll all line up after that.  I also popped out the seals in the oz forged wheel and noticed an extra little spacer, so need to make 100% sure the wheel does actually fit the bike.  Hassle I could do with out.